MaxStream 9XTend-PKG-E Manuel télécharger pdf (Page 20)

9XTend‐PKG‐E™EthernetRFModem–ProductManualv2.x4x[2007.01.04]

©2007MaxStream,Inc.,Confidential&Proprietary‐AllRightsReserved 20

4.RFModemConfiguration

4.1. Programming Examples

Refer to the ‘Command Mode’ section [p18] for information

regarding entrance into Command Mode, sending AT com-

mands and exiting Command Mode.

4.1.1. Configuration Setup Options

After installing the X-CTU and Com Port Redirector Software

[p8] to a PC, use one of the connection options below to send

commands to the XTend-PKG-E Ethernet RF Modem.

Option #1 - Local Network Connection

Connect a PC and the Ethernet RF Modem to active Ethernet connections of the same local net-

work [as shown in the figure below].

Figure4‐01. LocalNetworkConnection

Option #2 - Direct PC Connection

Connect the Ethernet RF Modem directly to the PC through the PC's Ethernet port [as shown in the

figure below].

Figure4‐02. DirectPCConnection

Configuration Setup:

1. Install both the X-CTU Software and the Ethernet Com Port Redirector [See 'Install Soft-

ware' [p8] section for more information].

2. Connect the Ethernet RF Modem to a PC using either a Local Network [Figure 4-01] or a

Direct PC [Figure 4-02] connection.

3. Follow the steps outlined in the 'Ethernet RF Modem Discovery' section [p9] to identify the

com port that will be used to configure the RF modem.

4. Launch the X-CTU Software on the PC and select the PC Settings tab.

5. Make sure values shown in the fields of the 'Com Port Setup' section match those of the

Ethernet RF Modem.

[Example is continued on the following page.]

Examplesinthissectioncitethe

useofMaxStreamʹsX‐CTUSoft‐

wareforprogrammingtheRF

modem.Otherprogramssuchas

TelnetSoftwarecanalsobeused

toprogramthemodem.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 61 62

Pas de commentaire

MaxStream 9XTend-PKG-E Manuel Page 20