MaxStream XStream-PKG-R RS-485 Manuel télécharger pdf (Page 12)

XStream‐PKG‐R™RS‐232/485RFModem–ProductManualv4.2B

©2005MaxStream,Inc.Confidential&Proprietary   12

3. ModemOperation

3.1. Serial Communications

3.1.1. RS-232 and RS-485/422 Data Flow

Devices that have a UART interface can connect directly through the pins of the XStream Modem

as is shown in the figure below.

Figure3.1. SystemDataFlowDiagraminaUART‐interfacedenvironment

(Low‐assertedsignalsdistinguishedwithhorizontallineoversignalname.)

3.1.2. Host and RF Modem I/O Settings

Serial communications between a host and an XStream RF Modem are dependent upon having

matching baud rate, parity, stop bit & number of data bits settings. Refer to the table below to

ensure host serial port settings match those of the XStream RF Modem.

Table3.1. ParametervaluescriticaltoserialcommunicationsbetweentheRFModemandhost

Parameter Setting XStream RF Modem Default Parameter Value

Baud (Serial Data Rate) 9600 bps or 19200 baud (Factory-set RF data rates)

Number of Data Bits 8 (NB parameter = 0)

Parity None (NB parameter = 0)

Number of Stop Bits 1 (NB parameter = 0)

Both the XStream RF Modem and host (PC) settings can be viewed and adjusted using

MaxStream’s proprietary X-CTU Software. Use the “PC Settings” tab to configure host settings.

Use the “Terminal” or “Modem Configuration” tabs to configure the RF Modem settings. Refer to

the Modem Configuration sections for more information.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 44 45

Pas de commentaire

MaxStream XStream-PKG-R RS-485 Manuel Page 12